Atik Cameras

Author Topic: "Cannot load Artemis / Atik DLL" error when started with Nebulosity 4  (Read 5516 times)

YAMADA masami

  • Guest
Hi,

Maybe I should raise this issue in the Stark Labs forum.
In Nebulosity 4.4, when connecting to my ATIK 460EX OSC after selecting ATIK Universal, I get an error message "Cannot load Artemis / Atik DLL", resulting in connection failure.  This only happens for Core Software ver. 5.0.x.x.  Strangely Windows 10 correctly recognizes the camera and Artemis capture works successfully.
Until Core Software ver. 4.2.2.9, this problem never happened.  As for ASCOM selection, any Core Software version works well.  Therefore I can avoid this issue by using ASCOM driver so far.
Any thoughts?

masami

Attebery986

  • Newbie
  • *
  • Posts: 1
Re: "Cannot load Artemis / Atik DLL" error when started with Nebulosity 4
« Reply #1 on: February 27, 2020, 09:16:02 am »
Same things are happening here.

vince

  • Atik Staff
  • Sr. Member
  • *****
  • Posts: 283
Re: "Cannot load Artemis / Atik DLL" error when started with Nebulosity 4
« Reply #2 on: February 27, 2020, 10:15:56 am »
The Atik Universal driver has been phased out for 3rd party software, our intention is to only support the ASCOM driver for the future.

I hope this answers your question.

Best regards
Vince