Atik Cameras Forum
Support (Please note, this is primarily a user forum, for direct Atik support, please email support@atik-cameras.com) => Accessories => Topic started by: sazam91 on August 30, 2013, 06:24:03 am
-
Hi everyone,
I just received my Astrodon Gen 2 LRGB filters (36mm unmounted) and was wondering what the correct way of installing them is. Right now, I simply put the filters in the slot (without the O-rings) and used the screws to secure them (without using the smaller white spacers). Even after this, my filters seem a little loose. Did I install them wrong? Can someone please provide me direction as to how to install them (photos too if you have them)? I'm seeing that if I use the spacer on the screw, it may obscure the filter by a little. Is it normal?
Thanks,
Sal
-
Sal
You need the rubber O rings at the bottom and then sit the filters on top. Secure with the screws and white plastic washers which will compress the filter on to the O-Ring a little. The face of the filters should then sit flush with the filter carousel. The minor intrusion of the washer into the filter is not an issue.
Chris
-
Hi Chris,
The trouble with that method is that the filter itself is not flush. It's still propped up withthe O ring on the bottom. How did you ensure its flush within its space?
-
I was able to secure the filters by using the smaller white spacers with the screws. The spacers keep the filters down and secure. OPT confirmed that even though the spacers may protrude a little on the filter, i wont have an affect on the final image.