Atik Cameras Forum

Support (Please note, this is primarily a user forum, for direct Atik support, please email support@atik-cameras.com) => 3- and 4-Series Cameras => Topic started by: bilgebay on February 12, 2012, 03:58:58 pm

Title: 428EX + Hyperstar - Correct filter size
Post by: bilgebay on February 12, 2012, 03:58:58 pm

I am planning to buy this camera and use it with my C11 Edge + Hyperstar setup. What size filter you would recommend to avoid vignetting. I will build a drawer type filter changer for this setup do I can design it so that the filter is mounted with 0.5mm from the tip of the camera. Would that configuration allow me to use 1.25" filters ?

Title: Re: 428EX + Hyperstar - Correct filter size
Post by: riklaunim on February 12, 2012, 04:13:58 pm

1,25" filters are ok. The sensor has a not so big 2/3" diagonal.

Title: Re: 428EX + Hyperstar - Correct filter size
Post by: bwa on February 12, 2012, 07:55:15 pm

I'm using 1-1/4" LRGB and narrowband filters with the 428Ex with no problems with several reflectors/refractors but have no experience using filters with Hyperstar.

bwa

Title: Re: 428EX + Hyperstar - Correct filter size
Post by: bilgebay on February 13, 2012, 06:41:33 am

Thank you both.

Hyperstar is f/2. This stretches many filter-camera combinations to their limits.

It's good to know that I can use 1.25" filters with my other configurations.

If there are any Hyperstar + 314L+ or 428EX, I will appreciate their input.

Clear skies.

Sedat