Atik Cameras Forum
Support (Please note, this is primarily a user forum, for direct Atik support, please email support@atik-cameras.com) => Atik Air => Topic started by: aztecdave on November 13, 2017, 09:31:15 am
-
I have a Raspberry Pi3 running StellarMate with its software running well. I would like to install AtikAir on the same card do I can switch to it to use my Infinity.
Can I install air using the installation procedures provided bt Atik. Is their anything I soulf be aware of?
Regards
David
-
I have now installed AtikAir on a seperate sd csrd using the"simple" procedure to seeo how it all works together............ so far sadly it doesn't!
1). I have got AA to install on the freshly formatted sd Card
2) I have got the sd catd to run onthe RPi3 B and after finding the correct user name and password (this eould be bettrr included in the set up text st the chronological point in the procedings).
3) Once these are entered the screnn shows "pi@raspberrypi........ and then a prompt expecting some input but the instructions/manual suggeedt that one goes to the pc and follows the setup procedure from there.
4) On the pc I get responses telling me that AtikAir is resdy and so I plug my Infinity in with the infinity softwsre running on the pc.
5) BUT I don't get a green camera connected lozenge and no further action.............
HELP
The RZPi is aldo connected by ethrrnet to a hub but my ZPC is connected to the hub by wifi.
What is my way forward?
Regards,
David
-
Update.........
Following the update issued by Atik to the Atik Air software included in the Artemis software this now installing and working fine.
Thanks to the Atikteam and Chris in particular for getting this sorted.
David
-
Thanks for the update, David, great to hear it's all working fine now.
Jo
-
Can I pull out the SD Card? Can you please tell me?
-
So Dave, were you able to get AtikAir services running on the StellarMate sdcard? If so, would you mind letting us know what was involved?
I have StellarMate running on the RPi but get install errors trying to install the AtikAir services.
ie.. Now we install the AtikAir services:
This step downloading and installing the Atik Air service for the raspberry pi.
1) Open a terminal on your Raspberry Pi.
2) Run the following command to download the software:
wget downloads.atik-cameras.com/AtikAir.tar.gz
3) Once done, run the following command to unzip the folder:
tar –zxvf AtikAir.tar.gz
4) Once done, run the following command to change into the correct directory:
cd AtikAir
5) Then run the following command to install the software. Enter your password if necessary.
Sudo ./Installer
-
I wil not be able to get back to this for a little while. Once I have got my AtikAir set up working reliably on its dedicated sd card, I will trg to run it on the card with Stellarmate installed as I think being able to switch between the two setups so I can use the infinity software to capture images the preferable way to go.
If, in the meantime, anyone else gets this working, please tell all!
David