Atik Cameras Forum

Support (Please note, this is primarily a user forum, for direct Atik support, please email support@atik-cameras.com) => 3- and 4-Series Cameras => Topic started by: YAMADA masami on February 19, 2020, 11:04:32 am

Title: "Cannot load Artemis / Atik DLL" error when started with Nebulosity 4
Post by: YAMADA masami on February 19, 2020, 11:04:32 am

Hi,

Maybe I should raise this issue in the Stark Labs forum.
In Nebulosity 4.4, when connecting to my ATIK 460EX OSC after selecting ATIK Universal, I get an error message "Cannot load Artemis / Atik DLL", resulting in connection failure.  This only happens for Core Software ver. 5.0.x.x.  Strangely Windows 10 correctly recognizes the camera and Artemis capture works successfully.
Until Core Software ver. 4.2.2.9, this problem never happened.  As for ASCOM selection, any Core Software version works well.  Therefore I can avoid this issue by using ASCOM driver so far.
Any thoughts?

masami

Title: Re: "Cannot load Artemis / Atik DLL" error when started with Nebulosity 4
Post by: Attebery986 on February 27, 2020, 09:16:02 am

Same things are happening here.

Title: Re: "Cannot load Artemis / Atik DLL" error when started with Nebulosity 4
Post by: vince on February 27, 2020, 10:15:56 am

The Atik Universal driver has been phased out for 3rd party software, our intention is to only support the ASCOM driver for the future.

I hope this answers your question.

Best regards
Vince