Atik Cameras

Author Topic: M1  (Read 5877 times)

dpaul

  • Full Member
  • ***
  • Posts: 134
M1
« on: October 02, 2018, 09:46:50 pm »
Attached was taken with Atik Horizon Mono camera with LRGB frames of 15 seconds each (2x2 binning).
Scope is 30'' F3.5 Dob on unguided equatorial platform, with Paracorr type II coma corrector.
All processing done in Pixinsight.

David

CraigG

  • Full Member
  • ***
  • Posts: 189
Re: M1
« Reply #1 on: October 15, 2018, 01:52:42 am »
Outstanding David!

Craig

dpaul

  • Full Member
  • ***
  • Posts: 134
Re: M1
« Reply #2 on: October 18, 2018, 09:56:53 pm »
Thanks Craig,

David

CraigG

  • Full Member
  • ***
  • Posts: 189
Re: M1
« Reply #3 on: November 16, 2018, 01:39:50 am »
Hi David!

Finally got some decent weather here to give M1 a try. Can't match what you did with your Horizon but still having fun with the Infinity OSC. 90 subs at 15 seconds with a little post-processing in Windows 10.

bwa

  • Sr. Member
  • ****
  • Posts: 298
Re: M1
« Reply #4 on: November 19, 2018, 01:15:05 am »
Very nice result!  I can almost see that rotating Neutron star in the center.

bwa

Attached was taken with Atik Horizon Mono camera with LRGB frames of 15 seconds each (2x2 binning).
Scope is 30'' F3.5 Dob on unguided equatorial platform, with Paracorr type II coma corrector.
All processing done in Pixinsight.

David

CraigG

  • Full Member
  • ***
  • Posts: 189
Re: M1
« Reply #5 on: November 19, 2018, 01:44:05 am »
Thanks bwa!

dpaul

  • Full Member
  • ***
  • Posts: 134
Re: M1
« Reply #6 on: November 20, 2018, 11:11:43 pm »
Hi Craig

Not a bad first result!

Regards

David

vince

  • Atik Staff
  • Sr. Member
  • *****
  • Posts: 283
Re: M1
« Reply #7 on: December 05, 2018, 11:08:15 am »
Hi David,

That is excellent :)

Vince

dpaul

  • Full Member
  • ***
  • Posts: 134
Re: M1
« Reply #8 on: December 09, 2018, 10:14:58 pm »
Thanks Vince,

I think its can be done even better with additional frames and perhaps a lower gain setting.
Must try this again when the weather lets me!

Thanks

David